Syvecs 4WD/AWD Controllers

The 4WD/AWD Controller is designed to integrate into any vehicle via the use of a configurable CANbus communications system.  Users are able to receive real-time data from the OEM/Aftermarket systems and uses this data for operational and monitoring strategies, resulting in a precise and accurate control of AWD/4WD control systems.

Specifications

Hardware

88 x 89 x 40mm
IP67 Sealed in Automotive Spec
Operating Temperature -40c to 125c
34 way Superseal 1.0 connectors
6 to 26V input voltage range
Ignition Switch Logic with high current supply

Outputs

4 x Half Bridge Outputs (15Amp Peak (100ms) 8Amp Continuous)

Inputs

4 x Analogue or switch inputs (0-5v)
4 x MagnetoResistive inputs

Communications

USB For Updates and Config
1 x CAN 2.0B interface for communication with other controllers or logging systems
1 x Kline Interface
6 Axis IMU Chip

Map Options

4 x Base Duty Tables

4 x Adders with enable maps

Left foot braking
Front Slip
Rear Slip
Centre Slip

Multipliers with enable maps

Steering Angle
AWD Temp
AWD Pressure
AWD Potentiometer
Manifold Pressure
Gear
Post Shift
AWD Trim Pot
Tyre Diameter adjustment under sensors

2WD/ Burnout Mode 

Via Dedication Switched input
Via Can bus Message
Via OEM Functions

Limiters

Maximum Duty
Launch Control Limit
Duty Rate of Change
Decay/Hold Functions

Limp Mode

Over Current Protection
Over Slip Protection
Over Temp Protection

Cooling Pump control

AWD Cooling pump control logic

Datastream

The Generic unit has full flexible CAN Receive and Transmit

Sensors / Switches

External sensors can be connected to the AWD module and then linearised in the Syvecs Scal Software